Prepare clean scissors and cut off the rose branches that have basically blossomed. Keep 3 bud points for each branch. Cut flat at the upper end and 45 ° obliquely at the lower end. Leave 1-2 pairs of leaves at the top.
The branches of different varieties are marked with notepaper, and the diluted rooting powder solution is prepared. The lower end of the cuttings is put into the water for an hour, and the anti precipitation is often stirred during the period.
The cutting basin is most suitable for using disposable plastic cups. Six cups are folded up, and a hot screwdriver is used to poke them in. Many small holes can be pierced at the bottom of the cup as drainage holes.
The cutting medium is perlite and vermiculite, with the particle size of 5-10 mm. The ratio of vermiculite and perlite is 2:1. It can be mixed fully and put into a cup.
When cutting, you can find a chopstick, insert the chopstick into the cup, then insert the branch next to the chopstick, and lift the chopstick up at the same time, which can prevent the base of the rose cuttings from being damaged.
The depth of the cutting branch is half of the height of the cup. After cutting, put the cup in the tray, pour water into the tray, and let the substrate absorb water from the vent hole at the bottom of the cup.
Usually, there is always water in the tray, and clean water can be changed every other time, and water can also be sprayed on the leaves. About 20 days later, the root system of the white flower can grow to a full cup.
The artificial flowerpot should be small, the ordinary two-color basin is OK, the soil can match by itself, for example, coconut bran: coconut shell: Perlite: peat: loose phosphorus = 5:3:2:3:2, do not add fertilizer.
Pour out the rooted rose with plastic cup cutting, shake off the vermiculite attached to the root gently, and be sure not to break the root system.
Install half of the basin soil in the prepared two-color basin, make the soil into a small hill bag, with the middle high and the four sides low. Sit the rose seedlings on the soil, support the seedlings with one hand, fill the soil with the other hand, and do not press the soil.
After transplanting, hold the seedlings with one hand and spray water with a watering can with the other hand. After spraying twice, the soil can be basically combined with the root system, which can prevent the root from being damaged by medium pressure soil during the planting process.
In the process of cutting and planting, give a little light to the rose, pay attention to ventilation, which is enough for the normal growth of the plant. After a week of survival, gradually add light to the whole day.
After all, it's a small basin for artificial planting, and it's a plain soil without fertilizer. We can wait until the rose root system is full of the artificial basin, and then we can transplant the soil lump into a large flowerpot, and the bottom of the basin can be buried with chicken manure.
After the young rose seedlings are planted, you can apply light huaduo No. 1, or meleko universal nutrient solution, and then use huaduo No. 2 to promote flowering before the plants grow and bloom.
