ThePlantAide.com

How to make Wisteria bonsai

Lydia Rodarte-Quayle
2020-08-31 11:00:03
To make Wisteria bonsai, you can buy seedlings directly from the florist, and prepare for potting after the whole seedling. The soil should be fertile and well drained rotten leaf soil and common soil, and the basin should be purple sand basin. Put the seedlings in the basin and then trim them. Branches should be scattered up and down, but the level should be less, not more, to avoid monotony, try to make it fuller.

How to make bonsai

Wisteria potted picture

Miao yuan

Which method can be adopted for seedling selection, but most tree families basically buy seedlings directly from flower shops, which has a high survival rate. But there are a few who like to cultivate from seeds. Xiaobian will give you a worship first. For detailed methods, please see another article of Xiaobian about the propagation methods of Wisteria flower!

Upper basin

The seedlings should be potted after finishing, usually in February to March, it is better to plant before the wisteria leaves grow.

Pot soil usually uses fertile, drainage good rotten leaf soil and common soil collocation, of course, you can also buy professional pot soil.

The flowerpot should choose the deep purple sand basin, the shape is various, according to the personal preference choice.

modelling

At this time, the most important step is to pave the front. If the first few steps are the process of girls going to the street to make up, the modeling is equivalent to going to the street to show, good or bad depends on the evaluation of passers-by. In short, pruning should adhere to one principle, simple and natural.

The branches should be scattered up and down, but the layers should be less, not more, but avoid monotony, and the plants should be as plump as possible.

There are many forms of bonsai, such as curved dry or inclined dry (the trunk of bonsai grows askew to one side), vertical branch (the trunk grows short and vertical) and attached stone (the trunk grows according to attached small rockery). According to the personal view of Xiaobian, inclined dry-type is more beautiful, and the cost is lower, good maintenance!

Wisteria potted picture

Later curing

To plant a pot of wisteria, we need to know how to conserve it. We need less water, more fertilizer, frequent pruning, and turn the pot early!

Less watering

Wisteria has a strong water absorption ability and needs a lot of water for its growth. But make sure the basin soil is only dry and not wet. Too wet pot soil is not conducive to flowering. Watering should adhere to the principle of "no drying, no watering, no watering". Especially in August, when plants grow flower buds, watering should be reduced and normal watering should be resumed in September.

Wisteria potted picture

Multiple fertilization

It is an important measure for Wisteria to apply thin fertilizer frequently. In the growth period of wisteria, we can combine watering and apply cake fertilizer once every 15 days, but stop applying fertilizer between July and August. Increase P fertilizer properly before flowering.

Frequent pruning

If you want to plant wisteria in a pot with luxuriant branches and leaves, you should remove the denser buds in time when they grow new buds in spring. If the new branches are too long, they should be pruned in time, usually no more than 15 cm. At ordinary times, the diseased branches and weak branches are often observed and pruned, even in winter dormancy period. In September, wisteria leaves will age and droop. Remove the old leaves in time to promote the germination of new leaves!

Early turning Basin

Turn basin as early as possible, and try to turn basin in early spring, 2-3 years.

picture of Wisteria potted plant

The Plant Aide - Plant experts around you

The Plant Aide - Plant experts around you

www.theplantaide.com