ThePlantAide.com

Cutting of spring leaves

Walter White
2020-09-22 09:19:28
The cutting time of spring feather is from May to September, which can promote rooting as soon as possible. Cutting can use sandy soil, pay attention to maintain ventilation and drainage. Select the robust stem nodes on the plant, ensure that there are 2-3 stem nodes, and remove the leaves of the lower part. The soil should be well organized, and then the branches should be dipped into the rooting powder, which can be inserted into the soil. After cutting, pay attention to the later maintenance management and wait for the roots to grow as soon as possible.

I. time selection

The cutting time of spring feather is suitable from May to September. At this time, the climate environment is very suitable for growth and can promote rooting as soon as possible. Other seasons can also be cutted, but the survival rate is not as good as that period. If the cuttage is selected in winter, the temperature must be good. Move it to the room for operation and maintain a good temperature, which is helpful for rooting.

Haruha

II. Preparation of soil

Before cutting, appropriate soil should be prepared. Sandy soil can be used. Pay attention to the effect of ventilation and drainage, so as not to accumulate water in the soil. Otherwise, the bottom of branches will rot, seriously hindering the later growth.

Haruha

III. cutting branches

As for the cutting of branches, special attention should be paid to this point. The robust stem nodes on the plant can be selected. Only when there are 2-3 stem nodes above, can the rooting be ensured. The branches should be treated properly, and the leaves of the lower part should be removed and not left on the top. If cutting is not carried out immediately, it can be placed in a well ventilated room with proper water spray to keep moisture.

IV. cutting

The soil shall be well organized, and then the branches shall be dipped with rooting powder to be inserted into the soil. The surrounding soil shall be slightly compacted to make the cuttings firm. Pay attention to the later maintenance management and wait for the root to grow out.

Chun Yu

The Plant Aide - Plant experts around you

The Plant Aide - Plant experts around you

www.theplantaide.com