1, prepare two foam boxes of the same size, which are used as clay boxes and storage tanks respectively, as well as burnt honeycomb briquette and two diameter PVC pipes.
2, cut the diameter of the PVC pipe to 5-7 mm shorter than the foam box, then put it upright in the center of the storage tank. Under the tube, 4 small tiles of 5 millimeters thick are placed underneath. The total height of the main pipe after the cushion can not exceed the height of the inner diameter of the storage tank.
3. Smash the honeycomb briquette, then put it into the large pipe, and pour 5-10cm thick water into the water storage tank.
4. Align and press the soil box on the water storage tank, then press hard to make the big pipe leave a mark at the bottom of the soil box, and dig a hole at the bottom of the soil box along the inside of the mark.
5. Dig a small hole on the corner of the soil box, PVC pipe with a diameter smaller than the small one, and place the small pipe on the small hole. The small hole is used to observe the water level of the water storage tank, and it can also be used to add water and fertilizer.
6. After handling the two boxes, put the soil box on the water storage tank and fill it with soil. You will find that the water is slowly sucked up. Often not at home friends, you can try to use this method to conserve plants or vegetables.
1. Cut all the leftovers or picked leaves, and mix them with a little mud.
2. If there is a pet at home, you can put a little pet manure, not too much, which is conducive to accelerating decomposition.
3. After finishing, if you feel very dry, pour a little water. Finally, cover with a layer of soil, so as to isolate insects and odor.
4. In summer, when the humidity is high, it is necessary to ensure that the composting box is in a relatively dry state. It is better to place the box in a well ventilated place. In summer, about a month time, fat on the pile, rich in nutrition and do not recruit insects!
1. Prepare foam boards, scissors, tapes and mineral water bottles for cuttings.
2. Take Gardenia as an example, cut several fresh and robust branches, and keep at least 1-2 bud points on each branch.
3, cut the foam board into a circle, put a few holes on it, and put the Gardenia trimmed into it.
4, scissors cut from the 1/3 of mineral water bottles, do not cut, pour half of the water, gardenia and foam board into a mineral water bottle, the bottle cap stamped several holes to tighten.
5, about 10 days, gardenia can take root!
1, cut the foam board into a circle, the diameter is smaller than that of the flowerpot, and cut a hole on the circular plate.
2, round the foam board through the main stem of the pot, and put it on the potted plant that needs insecticide.
3. Put an upside down washbasin or stool on the ground, and put the flowerpot on it.
4. Turn on the faucet and wash the leaves with worms by hand. It won't be long before the insects on the leaves are cleaned
5. After cleaning, put the flowers in the ventilated place to dry, and then maintain them normally!
