Ramet propagation can be carried out when the temperature reaches 20 degrees. It can be done without spring and autumn.
Use a sharp knife to cut its roots into small pieces, but select the roots with leaves and buds, cut them and insert them into the basin, then control the temperature between 20 ° C and 28 ° C, and the best degree of wetting is more than 80%. At this time, the basin soil should also maintain a certain humidity. If the humidity can not be guaranteed, can be wrapped with plastic film, afternoon can take off the film for watering.
Cuttage Propagation can be carried out at any time when the temperature is more than 20 ℃. Select the top and tender shoots of the plant, cut 10 cm to 15 cm long, which is equivalent to 1 /3 or 1 /2 of the leaves. After cutting, put them in a specific regulator that is conducive to their growth, soak them for 2 to 3 seconds, take them out immediately, and then insert them into the seedbed prepared in advance. If the reproduction is large, the recommended spacing is 5 cm x 10 cm..
It is also covered with plastic film, and the temperature is controlled above 20, and the humidity is kept at 80%. New roots can grow in about 30 to 50 days. Here, it is suggested that the novice friends should use ramets to propagate it, because the chance of cutting success is only 50%, and the ramets can reach more than 98% as long as the humidity and temperature are well controlled.
OK, now I know how to deal with it, and my friends who think it's OK can share it!
