1. Prepare a large plastic bottle, cut off one side after placing it horizontally, fill it with soil, bend a thick wire, bend the wire into S shape, and insert one end into the mouth of the plastic bottle.
2. The outside of the plastic bottle shall be coated with cement, and the contact between the bottle mouth and the wire shall also be coated with cement. In order to create the appearance of white swan, white cement can be made by mixing cement and gypsum.
3. Find two wire nets longer than the plastic bottle, and stick them to the outside of the plastic bottle as the two wings of the swan.
4. Then cover the wire mesh with cement.
5. The part of the thick iron wire can be twined with gauze or white cloth in a circle, and then cement is applied on the cloth.
6. In a few minutes, a swan flowerpot can be made. Don't forget to drill the hole at the bottom, or the flowerpot will be impervious.
7. Finally, don't forget to draw the eyes and mouth of the swan, and then plant flowers directly in the Swan pot!
1. Prepare the required materials: an irregular shaped fruit plate, a plastic cup and mixed cement. First clean up the inside of the irregular plate, then put a layer of glue on the inner wall of the plate.
2. On the outer wall of the prepared plastic cup, apply a layer of glue around the cup.
3. Put the mixed cement in an irregular basin until the whole basin is filled.
4. Press down the plastic cup in the middle of the basin filled with cement, do not press it to the bottom, make the upper part of the plastic bottle slightly higher than the cement surface, and then turn the basin back, pierce a few holes at the bottom, to achieve the purpose of water permeability and air permeability.
5. After that, put it in the sun. When the cement is completely dry, take down the plastic bottle and the outside basin, and make a beautiful irregular cement flowerpot.
6. According to this method, you can make flowerpots of all shapes you want. It's very beautiful to raise flowers!
1. Prepare a paper box, cut it into the shape as shown along the corner line of the paper box, then prop it up, and use the tape to stick out a half angle.
2. Fold the paper box into a three-dimensional prism, and then slowly pour the mixed cement into the paper box.
3. Find a plastic bowl smaller than the paper box and press it down in the center of the box filled with cement. Then use chopsticks and other things to poke a few holes at the bottom, as a drain hole.
4. After exposure to the sun for a period of time, the cement can be fully set. When the cement is completely dry, you can take out the plastic bowl and paper box, so that a small cake flowerpot is ready
5. If you think the flowerpot made by this way is not beautiful, you can also smear your favorite color on the flowerpot made by this way!
1. To make a leaf flowerpot, you need to prepare materials such as cement, large leaves, dyes and soil.
2. Spread out the soil layer, then spread the leaves on the soil, press it a little bit, try to make no space between the leaves and the soil
3. Pour the mixed cement on the leaves until the whole leaves are covered, and then make a few holes at the bottom to make it permeable and breathable.
4. When the cement is completely dry, remove the leaves from the cement, and a cement flowerpot is ready.
5. If you think the color of cement is ugly, you can dye it into any shape you like.
In addition to the above Flower introduction of these cement flowerpots, in fact, there are many beautiful flowerpots that can be made with the simplest cement!
