There is a basin of jasmine on the windowsill. The whole house is fragrant. It smells so good. How to insert Jasmine in water? Here's the introduction of flowers!
1. The cut branches of jasmine flower should be just after flowering, at this time, the meristem is more active and the roots are fast, as shown in the figure below:
(photo Author: moon reflecting bamboo source: Jasmine bar)
2. Trim the branches of jasmine, select the robust part in the middle, remove the weak growth at the top and the aging part at the bottom, keep two nodes and two leaves, the leaves can cut half, reduce water evaporation.
(photo Author: moon reflecting bamboo source: Jasmine bar)
The cut Jasmine cuttings
(photo Author: moon reflecting bamboo source: Jasmine bar)
3, insert the trimmed Jasmine cuttings into the foam, insert the bubble two centimeters, and then float the foam onto the water surface. Depending on the moisture, jasmine will soon take root.
(photo Author: moon reflecting bamboo source: Jasmine bar)
4. If the temperature is right, you can see the root system in one month. During the growth period, if you find that the water quality is bad, you should change the water in time.
(photo Author: moon reflecting bamboo source: Jasmine bar)
5. The root system of the white flower is so pleasant. You should try it soon. It's very simple
(photo Author: moon reflecting bamboo source: Jasmine bar)
6. Wait until the root system is developed, you can use the basin. Pay attention to the use of loose and breathable soil, otherwise it is easy to rot.
(photo Author: moon reflecting bamboo source: Jasmine bar)
7. Do not apply fertilizer to the newly potted jasmine, put it in a cool place for two days, and then put it in a place with sufficient light for maintenance.
(photo Author: year x year x fish source: Jasmine bar)
In order to make Florist Kalanchoe and branches flourish, we often pick the heart of Florist Kalanchoe. Don't throw the picked heart away. It's also a pot of Florist Kalanchoe in hydroponics.
1. 3 terminal buds of longevous flower.
2. Take a piece of cardboard and dig three holes to fix the long-lived flower cuttings.
3. Fix 3 long-lived flower cuttings on the cardboard, then fill a water cup with water, put the cuttings on the water cup, and the end of the cuttings should touch the water surface.
4. In about two or three weeks, the white root system will grow and can be transplanted after the root system is strong.
5. The transplanted soil must be loose and breathable, because Florist Kalanchoe are fleshy flowers, which are prone to decay due to excessive moisture.
6. The longevity flower can be cultured in shade for two days, then it can be moved to a place with sufficient light for normal maintenance.
1. It's hard for a skillful woman to cook without rice. Before cutting, of course, you should select the cuttings to ensure that the mint you cut grows healthily without pests and diseases. The stronger the branch, the higher the rooting rate!
2. Find a sharp scissor, cut a mint branch, and try to pick a good scissor. The length is about 10 cm, and there can be three nodes on it.
3. Roll down the bottom leaves of peppermint, and then put the peppermint branches into a hydroponic container for hydroponics. I can make a mint tea with my mint leaves.
4. Put the hydroponic Mint in a bright and well ventilated place. Change the water every other day. After a period of time, you can see the white root system, which is clean and sanitary.
5. After the root system of Mentha haplocalyx grows, we can choose the loose and breathable soil, and transplant Mentha haplocalyx to the flowerpot, so that the cuttage of Mentha haplocalyx can survive 100%