All year round.
In this way, reproduction is generally carried out in combination with basin changing. First of all, take out the tubers of the dormant plants, then take down the surrounding small tubers, put them in a well ventilated position for a little air drying, and then put them in the basin after drying.
In addition, large tubers can also be cut, but it is necessary to note that the tools must be disinfected in advance. Tuber cutting also has a certain method, try to ensure that every cut tuber has bud holes, so as to ensure that after planting, it can germinate faster and better.
In addition, we also need to pay attention to the selection of basin soil and try our best to meet its needs. We can choose the flower soil made of sand soil, peat soil and saprophytic soil with reasonable proportion. We'd better mix some bone powder in it, which is more conducive to the growth of plants.
Finally, the tuber will be buried in the flower soil, waiting for rooting.
It's better to do it in spring before the plant sprouts.
The method is relatively simple. Use clean tools, such as a knife, to gently cut the small balls growing near the plants, and then put them in a relatively cool place to dry them in the shade. They can be planted in about a day.
In addition, for the ball can also be cut, and then for planting, but in the operation, try to cut the section more smoothly, which is more conducive to the germination of the plant ball.
Put the treated seed ball into the container, fill the prepared soil and wait for germination.
Because it likes humidity and can withstand high temperature, after planting, it is best to put it at 20 ℃ ~ 30 ℃ and slightly humid place. In addition, it is best to put it in a half - shade place to maintain
In winter or areas with low temperature, do a good job in heat preservation, because this is a plant that is not very resistant to low temperature, and the substrate for planting should be loose and fertile as far as possible, so the flower leaf taro planted will be more beautiful!
