Fertilizing flowers is a troublesome, time-consuming and laborious job. If it's not well applied, it's easy for insects to take root. Today, flowers will teach you a convenient and clean fertilizing method. The fertilizing effect is quite good!
Operation steps:
1. Find a mineral water bottle, not too long, small mineral water bottle can, also not too wide, the diameter can not exceed 1 /6 of the diameter of the flower pot.
2. As shown in the picture, use sharp scissors to cut the bottom of the mineral water bottle.
3. Bury the mineral water bottle with the bottom removed into the pot soil. Pay attention to that the mineral water bottle is buried along the edge of the pot. Do not touch the flower root system, or it will easily hinder the growth of the flower root system and burn the root.
4. Open the lid of the mineral water bottle, you can cut the leftover fruit peel and the rotten vegetable leaves that you usually eat into small pieces, throw them in, and then tighten the lid, so that the rotten vegetable leaves and the fruit peel in it can ferment.
5. Because of the protection of plastic bottles, the roots will not be directly contacted and damaged during the retting process. After 2-3 months, the peel and leaves that are thrown in first will be completely decomposed, and then they will be able to replenish nutrients for the flowers. And later thrown in, will stay in the upper layer to continue fermentation
6. In this way, fertilize potted flowers, not only won't burn roots, but also very clean, won't recruit small insects, won't have peculiar smell, really worried that there will be insects in the bottle, you can spray some insecticides or throw some carbofuran.
Many flower friends are especially afraid of holidays or business trips, because no one watered the flowers at home for ten and a half days. When they came home, they all dried up and wanted to cry without tears! Last year, the old flower farmer told Huahua an automatic watering method. Last year, he tried it. He went home for the new year for one month. When he came back, the flowers were still green and green, with special spirit!
Operation steps:
1. Find a plastic washbasin, a little bigger
2. Prepare several watertight sealed bags or plastic bags, fill the bags with water, and fasten the mouth.
3. Put the water loving flowers such as Cyclamen, pothos, Spathiphyllum, and copperhead into the washbasin.
4. Put the plastic bag full of water into the washbasin. The number of plastic bags can be adjusted according to the length of time when you are not at home. If you are not at home for half a month, you can put one. If you are not at home for one month, you can put two on one side.
5. Use a needle on the plastic bag and gently pierce 2-3 holes. The holes should not be too large. Let the water flow out as slowly as possible, not too fast!
6. The water flowing out of the hole of the plastic bag will slowly penetrate into the bottom of the flowerpot through the permeable hole of the flowerpot, so that the root system can absorb the water for half a month or even a month, and because the hole is small, the water flow is slow, no water will accumulate, causing the root system to rot.
Recently, snow and temperature have fallen all over the country. Many flower friends' flowers have been frostbitten or even killed. It's heartache! Although the pain, but we must not give up treatment, and then quickly according to the following method, using foam box to build a small greenhouse for the flowers, cold weather is not afraid to freeze the flowers!
1. when buying seafood, fruits or electrical appliances, there will be foam boxes. Do not throw them away and pick them up completely. If there is no home, you can go to the fruit stand to buy a few.
2. prepare a few circles of wire or lead wire, first compare to the width of the foam box, make 2 arcs with iron wire, and each circle has 1 circles around it. The arc ends are inserted into the 4 corners of the foam box respectively, then the tape is wrapped around a couple of loops to fix it.
3. Cut a straight section of wire, pass through the middle ring of the arc wire, and then fasten each other.
4. Find a piece of plastic film, or a large plastic bag, and cover it on the wire rack we built, and wrap it with a leather band or tape.
5. On both sides of the film, open a small gap properly to facilitate ventilation. Then put a flowerpot into a small greenhouse, and it's OK! If the warmth is not enough, you can also spread some cotton padded clothes or thin quilt on it. No matter how cold it is, you are not afraid to freeze the flowers!
6. Because each family's materials and conditions are different, everyone can freely play according to the materials at hand.
Winter food is so expensive. I went to the food market for about one or two hundred yuan. It hurts! It's better to plant at home, just 10 plastic bottles, you can grow a winter food!
1. Don't throw away the plastic bottles left over from drinking water and drinks, and collect them with the same size and diameter.
2. Pick up the first plastic bottle and cut off the bottom with scissors!
3. Turn over the plastic bottle with the bottom cut off, tighten the cap, and then use scissors to poke several holes at the position shown in the figure below
4. Mix peat soil, perlite and vermiculite in the proportion of 4:1:1, mix well, and then put them into the first plastic bottle.
5. Place the plastic bottle filled with soil with the cover facing down beside the handrail, wall or iron frame, and fix it with tape or rope. Don't let it fall down.
6. Continue to cut off the bottom of 8 plastic bottles, fill them with soil, and pay attention not to drill water holes.
7. Cut off the bottom, install the plastic bottle of soil, remove the cover, and pile it together as shown in the figure below
8. Stack 8 plastic bottles onto the first one.
9. Use tape or rope to fix the plastic bottles just piled on the railing or wall.
10. Take the 10th plastic bottle, keep the cap, and punch some small permeable holes on the cap.
11. Cut off the bottom of the 10th plastic bottle and put it upside down on the top plastic bottle.
12. Pick up the watering can and slowly pour water into the 10th plastic bottle.
13. In this way, the water will gradually permeate through the cap of the 10th plastic bottle.
14. The water penetrates layer by layer until the soil of the first plastic bottle is completely soaked.
15. Use a wallpaper knife to cut out a small square window in the middle of the 1st-9th plastic bottle. Cut the top, left and right of the small window, and do not cut the bottom.
16. Finally, in the middle of each plastic bottle, a small plastic switch device is formed, which can keep the seedlings, seeds and soil from leaking out.
17. Open the plastic sheet, use your index finger to poke a hole in the soil.
18. Plant the vegetable seedlings or seeds that you want to plant into a small hole and bury the soil.
19. In addition to the top 10 plastic bottles, which are used to store and water water water, other bottles are operated like the above figure, planting vegetables, and finished.
20. If the vegetables need to be watered, pour the water directly into the top plastic bottle. If you don't want to water it too often, you can add 1-2 more water storage plastic bottles on it. If you need to apply fertilizer, just add compound fertilizer directly to the water! Very convenient! Indoor less than 2 months, vegetables on green, can be picked and fried to eat!
21. The small vegetable garden made by the above methods can also be planted on the corner of the house or on the customized wooden frame. It is not only convenient to plant, but also can eat fresh vegetables, and can form a beautiful landscape, adding a touch of green to the home!
Although many cutting methods have been introduced before Huahua, many flower friends still complain with Huahua. Cutting is so troublesome and difficult to take root. Today, Huahua will teach you a super simple cutting method, rooting is super simple!
Picture, creativity: Liu Haoran
1. Prepare a container to hold water. Wash basin, tank, water tank, etc. can be filled with water. The water level should be at least 5cm deep.
2. find some foam boxes, cut them into small pieces, and drill 1-2 holes in 1 holes in each middle.
3. Prepare cuttings, longevity, azalea, camellia, rose, gardenia and all other flowers are basically OK, the best way is to soak carbendazim in the branches in advance for 5-10 minutes, disinfect!
4. insert cuttings into the pores of the foam, then put the foam on the water surface.
5. Put the washbasin in the place of astigmatism and ventilation, don't worry about it. If you want to see if it takes root, just take it up and see it.
6. After the branches take root, they can be transplanted into the soil for normal maintenance.
These are very good ways to raise flowers
Huahua will be introduced here today
Flower friends, if you think these tricks are very good
Can be shared with more flower loving partners
Or leave a message in the lower right corner to share your flower cultivation tips!
