ThePlantAide.com

How to raise flowers when the balcony is too small? Bend a wire in one pipe and make a three-dimensional flower stand!

Lydia Rodarte-Quayle
2020-07-20 08:40:15
When it comes to flowers, many flower friends are worried. Huahua, you have recommended so many flowers, but the balcony is too small, and there is no place to raise them. What should I do? Don't worry. Today Huahua will teach you to make a three-dimensional flower stand. In the limited space, let you raise more flowers!

Trellis 1

Production steps:

1. Prepare PVC pipe drilling

Go to the hardware market to buy a 110cm or so PVC pipe with a diameter of about 7cm.

2. Drilling

On PVC pipes, holes are punched at an interval of 20cm. If you want to make two sides, punch two holes. If you want to make four sides, punch four holes. Today we need to drill 4 holes. The front and back holes are not on the same level as the left and right holes.

3. Wire bending

Bend the wire prepared in advance into an iron ring. The diameter of the bend depends on the size of your flowerpot. Don't use too thin wire, or it will easily deform.

4. The iron ring is inserted into PVC pipe.

Insert the bent iron ring into the PVC pipe one by one. The protruding part will go through the hole and bend down. Then find the iron wire and tie it tightly to prevent the iron ring from shaking.

5. PVC pipe fixing

Seal the bottom of PVC pipe, first pour 1 /4 of the sand into the flower pot, and then let the soil dry out, so that it is firmer

If there is an abandoned hanger base at home, PVC pipe can also be fixed on the base of the tripod, which can also enhance the fixity and prevent the pipe from skewing when it is placed on the flowerpot.

6. PVC pipe fixing

In this way, a three-dimensional flower stand is ready! Put the flowerpots you want to place one by one, and you're done! However, we need to rotate it every few days to prevent uneven illumination of flowers.

Three dimensional flower stand 2

Production steps:

1. Prepare PVC pipe

If there is no iron wire in Huayou's house, you can also make PVC pipe directly. First, prepare a PVC pipe with a length of at least 1 m.

2. Scoring and sawing

Mark the PVC pipe at an interval of 10cm, and then saw the marked part with a saw.

3. Hot press

After sawing, bake a little with fire, then take another pipe, press down along the sawing position, and make the sawing position form a groove

4. Seal the bottom

Seal the bottom of PVC pipe completely, so that a three-dimensional flower stand is ready!

5. Planting vegetables and flowers

Finally, fill the pipe with soil, and plant the plants or vegetables, even if it is finished!

In addition to the introduction of flowers, there are also many self-made flower racks. They don't take up space, and they are easy to raise flowers. Come and have a look!

flower rack

flower rack

Flower Rack

The Plant Aide - Plant experts around you

The Plant Aide - Plant experts around you

www.theplantaide.com