ThePlantAide.com

How to take a cutting for azalea

Skyler White
2019-12-22 14:38:34
Select the luxuriant branches, cut off from the root, trim the leaves, leaving only 2-3 leaves at the top; bind the pruned branches and soak them in warm water for half an hour; insert the soaked branches into the prepared basin soil, and compact them with your fingers; fully water them once and place them in the shade, and move them to a bright place about 3 weeks later.

I. cutting branches

Select the stronger growing mother plant, cut the luxuriant branches, cut from the root, remove the leaves under the branches, and keep the top 2-3 pieces.

Soak the branches.

Tie up the pruned branches, soak them in warm water for half an hour and prepare the soil.

3. Insert branches

In the prepared pot soil, poke a few small holes with your fingers, insert the soaked branches into the holes, and then compact the surrounding soil with your fingers to ensure that the branches are in full contact with the soil.

4. Water it well.

After cutting, water timely and fully. Put it in a cool and ventilated place. If the humidity is too low, you can wrap a layer of plastic film on the flowerpot. About 3 weeks, the seedlings can fully adapt. At this time, you can move to a bright place with astigmatism, and gradually adapt to the light, sun

Rhododendron

The Plant Aide - Plant experts around you

The Plant Aide - Plant experts around you

www.theplantaide.com