ThePlantAide.com

How do Rubber fig grow in strips

Jesse Pinkman
2020-05-13 09:03:48
The Rubber fig is usually pressed in the rainy season. We select the branches with brownish red color on them, which should not be too tender, and then skin them. The pressing method is complex, and the process includes peeling, etc. After pressing, make sure the humidity is high. After the white root grows, you can plant it in the flowerpot.

1. time

In this operation, you should choose the right season, preferably rainy season or summer, but the specific time needs to be on a sunny day

2. parts

It's best to grow a very vigorous plant. It's most suitable to grow a branch with one or two centimeters of aerial roots. Select the upper brownish red branch, and then peel the lower part where it has air roots. There will be a kind of raised point between its branches, here is the original base of air rooting, and then we will induce it to grow tender roots. We need to know that the place where it is peeled should not be too tender, otherwise it is easy to infect bacteria, and then directly rot, so we should pay attention to

3. method

First of all, we need to peel it. We need to use a knife to cut its stem into two circles. There should be an interval between circles. The interval is three times of the diameter of the branch and the slightly dried stem. Then we need to use a knife to pick out the skin in the middle, and then sprinkle it on the wound with charcoal powder, or we can wait for the juice of the wound to dry and then put the substrate on the top 10 cm place, or only use wet sand. A weight can be from one jin to two Jin. After applying the soil, we need to put plastic cloth on the wound, then wrap it with cloth, and finally tighten it to prevent the water from steaming out. After the rope is tied, a hole shall be left for the convenience of adding water to it or letting it receive the rain by itself. If the branch is very thin, we can support a stick or bamboo pole for it, and tie the earth ball on the stick or bamboo pole.

Rubber Tree

After 4. pressure

It can't be ignored after pressing. We need to make sure that the plastic bag is moist. If the humidity is not enough, we need to pour some water on the left slant mouth. In about 50 days, new roots will grow out. We can see that it is white. At this time, we need to cut the branches from the bottom of the soil, and then cut the plastic bag outside, and then we can plant it in a pot.

The Plant Aide - Plant experts around you

The Plant Aide - Plant experts around you

www.theplantaide.com