1. Take the Money Tree out of the basin, and pay attention not to damage the root system.
2. Clean the root system of Money Tree with clear water.
3. Check the root system of the Money Tree to see if there are any black and rotten trees. If there are any, cut them off with scissors.
4. Prepare new flowerpots and soil. The soil can be garden soil and sand, half of which can be used. Add sand, on the one hand, to make the soil more loose and breathable, on the other hand, to support the trunk.
Some large-scale Money Tree can't stand on nutritious soil at all and will fall. Small Money Tree can use nutritious soil.
5. The new flowerpot should choose the shallower one, because the root system of the Money Tree is shallower, and the soil in the too deep flowerpot is not easy to dry, which is easy to cause water accumulation.
Put some small stones or broken bricks and tiles on the bottom of the flowerpot to strengthen water permeability and avoid water accumulation. Then fill the basin.
1. Hold the pothos with one hand, turn the flowerpot upside down with the other hand, and take the pothos out of the basin first
2. Gently pat the soil lump of the root system of the pothos, remove the large soil, and finally clean the root system with clear water.
3. Check the root system of the pothos carefully. If there is any black spot, trim it off. And no black spot can be left.
4. Then soak the wound of the root system in carbendazim solution for about 20 minutes, and take it out to dry in the shade.
5. The new soil is best according to the ratio of peat soil: Perlite = 2:1, and perlite is mainly added to make the soil more loose and breathable.
6. Put the pothos in the pot again.
1. Before changing pots, stop water for 1 week, and let the soil and flowerpot separate.
2. Hold the bulb of Clivia in one hand, turn the flowerpot in the other hand and knock it out.
3. Pat the soil mass lightly, take some of the soil quickly, and then rinse the root of Clivia with water.
4. Observe the root system, remove the old root, withered root and blackened root system.
5. Soak the roots in carbendazim solution. After half an hour, take them out and dry them in the shade.
6. The soil ratio of 5 parts of garden soil, 3 parts of rotten leaf soil and 2 parts of river sand can be used.
At the same time, some seeds and slow-release fertilizer are buried in the bottom of the flowerpot.
Then cover the melon seeds with a layer of 3-5cm soil to prevent the root system of Clivia from directly contacting the soil.
7. The gap between the roots of Clivia is relatively large. Before putting it into the basin, first fill the middle part of the root with soil, then put Clivia into the middle of the flowerpot, while filling, pat the flowerpot to avoid the gap.
8. Water and put it in a cool and ventilated place for 1-2 days, and then take it out for sunshine.
1. Hold the stem of Florist Kalanchoe, turn the flowerpot upside down and knock it out.
2. Clean the soil on the root system of Florist Kalanchoe with clean water.
3. Check the root system of Florist Kalanchoe to see if there is any black and rotten place. It is not the best. If there is any, trim it with sterilized scissors.
4. Florist Kalanchoe is not very picky about the soil. It's good to mix a little sand in the general nutrient soil. Nutrient soil: the proportion of sand is 6:4.
5. Bury a little chicken manure in the bottom of Florist Kalanchoe as the base fertilizer. Cover the basin with soil.
1. Take off the pot of snake plant, pay attention not to hurt the root system of snake plant
2. Rinse the root system of snake plant with clear water, and carefully check whether there is any blackened part. As long as it is blackened, it is rotten. Cut it all off. If the root system is black, cut it all off.
3. Prepare new basin soil. The soil should be loose and permeable. Garden soil + river sand can be used, and the proportion is 1:1. Flowerpot should choose shallow, but the kind with larger diameter..
4. Apply carbendazim to the wound of snake plant. After sterilization, you can use it again!
1. Take off the bamboo.
2. It is not necessary to remove the soil completely, but a part of the root system should be left. Remove the edge of the soil can be, and then check the root system, there are black root system will be cut.
3. Prepare nutritious soil, ceramsite, pebble, etc.
4. Put ceramsite on the bottom of the flowerpot. If there is no ceramsite, use small stones instead.
5. Nutrient soil, perlite and coarse sand are mixed in the proportion of 3:1:1. Use as new soil. Bamboo does not like fat, so do not put fertilizer.
6. Don't put the bamboo in the pot with bare roots. Put the roots with soil in the pot, put the soil in the pot, and pat the pot gently to avoid the gap left by the soil.
7. Water the soil and put it in a cool place for 1-2 days to slow down the roots, and then put it in a place with sufficient scattered light for maintenance.
1. Knock the flowerpot on the ground to separate the soil from the flowerpot.
2. Clean up the root system of Chlorophytum, check whether there are black and rotten places, and cut off if there are any
3. Prepare nutritious humus soil and bigger flowerpots.
4. Bury some bean cakes in the bottom of the pot, and put the Chlorophytum back into the pot.
Pay attention not to let the root of Chlorophytum touch the fertilizer at the bottom.
1. Remove the meat from the basin and clean the root system. Cut off all the weak roots.
2. Allocate nutrient soil according to the proportion of peat soil 60% + sand 20% + particle 20%. At the same time, the bottom of the basin is padded with ceramsite to avoid water accumulation.
3. Put the meat in the middle of the flowerpot, fill it slowly and put it in the basin.
4. Do not water first, wait for 1-2 weeks and then water again. Drought can promote the growth of fleshy roots.
Put it in a cool and ventilated place for 1-2 days, then take it out for sun.
1. Happiness tree is generally large, so it's troublesome to change the basin. You can only change half of the soil, which can not only reduce the workload, but also reduce the damage to the plant root system.
2. Before changing the basin, cut off the water for about 10 days to separate the basin soil.
Then remove half of the soil on the surface of the flowerpot. Pay attention, this step should be very careful, and try not to break the root system of emerald tree
3. Prepare new soil, and configure it according to the ratio of garden soil: rotten leaf soil: rotten organic fertilizer: river sand = 5:3:1:1.
4. Fill the pot with new soil, then pour it through water.
1. First, water the jasmine once, wait for 1-2 days, and then change the basin when the soil is neither dry nor wet
2. Knock the outer wall of the flowerpot to separate the soil from the flowerpot. If it can't be completely separated, you can insert a knife into the part between the soil and the flowerpot wall to separate the two.
3. Clean up the soil and take care not to damage the root system of jasmine.
4. Clean up the roots of jasmine with clear water, and then carefully check the roots of jasmine. If there are black, dry and sick roots, they should all be cut off, and some too old roots should also be cut off.
5. Garden soil, heaped fertilizer soil and river sand are allocated in the proportion of 4:4:2. Put a little slow-release fertilizer, cake fertilizer and so on in the bottom of the flowerpot, as the base fertilizer
6. Then put the jasmine in the basin.
1. Take the triangle plum out of the basin, knock the soil mass of the triangle plum on the ground, knock all the soil on the edge
2. Remove one-third or one-half of the soil around the root system without removing all the soil.
3. When removing the soil mass, the vigorous root system of Prunus deltoides can also be removed by one third, or together with the soil mass.
4. The soil of delta plum can be configured with saprophytic soil + river sand.
You can also use half sand and half cinder, add a small amount of fish intestines and chicken manure for retting. This kind of soil is loose, breathable, not hardened, and has good fertility. It's great to use, but you should pay attention to that it can only be used after retting is completed. When changing pots, never put in raw fish intestines and chicken manure!
5. Put the bougainvillea in the basin again.
