Fragrant oil is rich in nutrients, which is good for watering flowers. Orchids have more fragrant flowers and greener leaves. It is better to regenerate and apply fragrant oil for a long time, with better effect. But the oil particles are relatively large, if one-time pouring too much, it is easy to cause soil hardening.
1. Take half a spoon of sesame oil.
2. Dig a small hole far away from the root system of orchid.
3. Pour the oil into the small hole and fill it with soil.
4. As the oil is relatively fat, the interval between them must be long, about once every 3-6 months.
In addition, it's not recommended to use small orchid seedlings or relatively thin orchids. It's easy to burn seedlings. Generally speaking, it's only for large and robust plants.
After the expiration of the sesame paste, a layer of oil is separated from it. In this case, people can't eat it, but it's very good to compost the sesame paste with the separated oil! Can provide a lot of nutrition for plants!
1. Put the sesame paste and the oil in a plastic bottle.
2. Add a small amount of water and close the cover. Be careful not to cover it too tightly.
3. Put it in the sun for fermentation. At this temperature, it is estimated that the fermentation can be completed in one month.
4. After retting, it must be diluted for use. Because of its high fertility, it is generally used by mixing the supernatant with water for 100 times, and the dregs can be put in a small amount at the bottom of the flowerpot as the base fertilizer.
Many people don't know what to do with the waste oil in the range hood. In fact, this kind of oil can be used to water the flowers.
1. Clean up the waste oil from the range hood and put it into the container.
2. Use chopsticks or sticks to poke 3-5 holes along the edge of the flowerpot. It's like a circle of red thread.
3. Pour waste oil into the hole, and pay attention not to fill all the holes. A part of good earth is leaked out and covered.
4. According to the actual measurement by Huayou, the effect of this method is very obvious. For the Clivia that has not flowered before, this year, it has a dozen flower buds directly, which is very good!
However, it should be noted that do not directly contact the root system!
In fact, it's called scum here. Huahua here is to squeeze peanut oil, and then put it into a bucket to keep, for a long time, there will be a layer of sediment under the bucket, that is, the so-called oil residue.
If it is planted outdoors, you can dig a deep pit near the plant and bury it. In the natural environment, it will slowly ferment, as long as it is far away from the root system, there is no big problem
But you can't bury too much in it. If you bury it in a bucket, it's estimated that you can't live anything. Basically, the quantity of a bowl is almost the same.
1. Prepare a big bucket with good sealing performance.
2. The bottom layer is buried in a layer of soil, then spread a layer of oil residue, and then another layer of soil, so repeatedly, until the whole barrel is filled.
3. It's not necessary to only fill in oil dregs. Some kitchen waste can also be put in.
4. Put the container outdoors, in the sun, in some areas with high temperature, it is recommended to choose a stronger bucket, and the flowers are afraid of being sunburned Basically, keep the current temperature for about one month.
5. Mix the soil well. It's better not to plant flowers directly, because it's too fat. It's better to mix it with the garden soil in the proportion of 1:1, and then plant flowers.
In fact, sesame oil residue is the residue of making sesame oil. It's very fat. It's great for making flower fertilizer, but it's too fat, so it can't be used directly. It must be fermented
1. Make the sesame oil residue into small pieces, like the one in the figure below, and you can make it twice smaller.
2. Put it into a plastic bottle or other container, add water, just without deodorant residue.
3. Seal it and expose it to the sun (it's recommended to use an iron bucket for high temperature, which can conduct heat quickly and ferment faster.)
4. When the liquid in the container turns black and there is no pungent smell, it means that the fermentation is finished and can be used.
5. It has high fertility, so it must be diluted many times when it is used. If it's fertilizer solution, it should be diluted 50-100 times, and it's better to use it for the fertilizer loving flowers like Clivia and jasmine.
6. The residue of retting can be used as base fertilizer when changing basin.
7. Or add it to the soil, stir it evenly, and use it directly as the soil. Note that 10 parts of garden soil and 1 part of dregs should be used to grow fertilizer loving plants.
Huahua introduced the oil of finished products, which may be reluctant by many flower friends, so we can use some oil crops to replace it, such as peanuts, soybeans, melon seeds, castor, sesame, rape and so on.
When changing pots for flowers and plants, you can directly bury the damaged oil crops in the bottom of the pot, and use them as the base fertilizer, and the microorganisms in the soil will slowly decompose them. Clivia, a fat loving plant, especially likes it!
Put the broken beans into the plastic bottle, pay attention, never fill it up, then add water, just do not pass the beans, then screw on the cover, never tighten it.
Take it out to bask in the sun, open it for ventilation in one day, or it will explode easily! When the water inside is black, it means that the retting is done
It can be mixed with water about 50 times to water flowers. The remaining dregs can be directly used as fertilizer, topdressing or base fertilizer.
