1. When the Junzi orchid is defeated, it will produce seed pods. When the seed pods become reddish brown, the seeds of Junzi orchid will mature. Then cut the seed pods and take out the seeds.
2. Soak the clean gauze in warm water, then wrap the Clivia seeds in gauze, and put them in a warm place after wrapping. It's better to cover them for 24 hours.
3. Spread the sawdust in the seedling basin, spray it with water, put the soaked seeds in the sawdust with the tip down.
4. Put the treated seeds in the astigmatism place, spray water once a day, morning and evening, after about 20 days, the seeds will sprout.
5. After the Clivia seed grows a complete small leaf, it can be moved out and planted in a flowerpot for maintenance.
6. After a period of maintenance, Clivia completed the transformation from seed to seedling!
1. Stop watering the orchid for 1-2 weeks before branching, so that the root of the orchid will become soft, so as to avoid too much water, breaking when branching.
2. In most cases, the roots of orchids grow intermingled. Before branching, you should separate the roots bit by bit, or you will easily tear many roots when branching.
3. Orchids are all one plant. Find the boundary between each plant and cut them along. In order to reduce the damage to the root, it is suggested that 3 - 5 plants should be separated as one plant, and then divided into a single plant.
4. After the plants are divided, use the sterilized scissors to cut off all the dead, empty and weak roots of the orchid
5. Soak the cut orchid root in carbendazim solution, disinfect it for about 30 minutes, and then take it out to dry.
6. When the orchid is disinfected, prepare several plastic bottles, cut them at the waist, iron several holes on the bottle body and the bottle cover with red wire, and cut several triangular notches on the cross section of the bottle.
7, put the treated plastic bottles at the bottom of the flower pot, and use the broken foam blocks to fix them. This will increase the permeability and permeability of the soil and avoid the rotten roots of orchids. Then put the prepared plant materials in
8. Put the divided orchids into the cultivation basin, so that one pot of orchids can become several pots!
1. Cut off the half lignified Clematis branches. Cut a knife obliquely 3-5cm below the upper node of each branch. Cut a knife 0.5cm-1cm above the bud point. Divide the branch into several segments.
2, prepare a clean foam board, use chopsticks to stab holes in the foam board, not too big.
3. Put a Clematis branch in each foam board hole, then put the foam board in the clear water. In order to promote rooting, you can put a little rooting powder in the water.
4. Put the cut Clematis in a cool and ventilated place, and make sure that the roots are immersed in water. After about 20 days, they will produce fine roots!
5. When the root system is more than 5cm long, it can be planted. Put a small amount of soil in the planting basin, put the clematis root system into the plate, continue to fill the soil, you can add a little slow-release fertilizer.
6. After planting, water mixed with carbendazim solution once. Then put it in a cool and ventilated place for maintenance. After a week, it can be maintained normally!