In order to get a pot of healthy rattan Panax notoginseng, we should choose the strong branches as the cuttings. The length of the branches should be kept at about 15cm. Each branch has two or three nodes where the female flowers are, so as to ensure the success rate of germination. It should be buried in the soil along the development direction of the leaves, 4-5cm deep, and at the same time, the spacing should be ensured, not too dense, so as to facilitate the rooting and growth of the branches, and at the same time, the soil in the flowerpot should be fully watered. In order to grow better, it is suggested to build a shed around the new seedlings, which must be stable, and then fasten it with plastic film, which is covered with soil. In this way, the survival rate can be increased.
It is very important to take good care of it after cutting. The first 7 days, it is better to control the temperature within 25-30 ℃ in the daytime and not lower than 10 ℃ at night. After 7 days, the temperature can be reduced by 3-5 ℃, between 22-25 ℃ in the daytime and 6-8 ℃ at night. On the third day after cutting, it is necessary to avoid sunshine and do a good job of shelter. Shade; the fourth day can be in the sun, but not too long and exposure.
If you want to cut in summer, you must do well in cooling and shade, so as to ensure the survival rate.
In fact, it is not difficult to cut the three and seven stems of rattan. As long as you are careful, you can observe and adjust the temperature and light of the four seasons.
