ThePlantAide.com

Cuttage Propagation of periwinkle

Walter White
2020-07-15 15:30:20
Before cutting, peat, perlite and vermiculite were used to prepare the soil according to the ratio of 4:1:1 and water it once. Cut 10 to 12 cm branches, and only keep 1-2 leaves on the top. The cutting depth is appropriate. Spray water in time and cover with plastic bag. Put it in the environment of 20-25 degrees, it will take about 20 days to root.

I. soil preparation

When cutting, the substrate is generally prepared with peat, perlite and vermiculite in the proportion of 4:1:1. After the preparation, it is put into the flowerpot and watered once for water permeability.

2. Cutting branches

Generally speaking, pinch 10 to 12 cm directly from the top to the bottom half, then cut off both sides with scissors, and cut off the leaves at the bottom, leaving 1-2 leaves at the top. Pay attention to the use of scissors, the best not to use hands, to avoid infection.

3. Insert matrix

After cutting, the cutting time is generally between June and September, during which the temperature is high, which is conducive to rooting. When cutting, the depth of cuttings is one third in summer and two thirds in spring. In summer, the temperature is high and perishable. In spring, the temperature is low and the humidity is low.

IV. later maintenance

After insertion, spray water timely and cover with plastic bags. If the condition is good, can make a seedbed, put on the film, pay attention to moisturizing. The best temperature control in 20 - 25 degrees, about 20 days can take root

Catharanthus

The Plant Aide - Plant experts around you

The Plant Aide - Plant experts around you

www.theplantaide.com