Longevity flower must be raised by many people ~ because it's so beautiful! However, the older the longevity flower is, the less it will bloom, because many flower friends will buy a new pot every year, in fact, it's not so troublesome. The longevity flower branch can take root quickly and feed well, to ensure that you have no shortage of Florist Kalanchoe every year!
Branch insertion steps:
1. Cut off the selected branches. Pay attention to that when cutting, cut them about 1cm above the axillary buds. When cutting, the mother plant can also be divided into branches.
2. Divide the reduced branches into sections, keep two nodes with leaves on each section, and then remove the leaves at the bottom.
3. Prepare suitable branch soil, peat soil, nutrient soil, river sand, vermiculite, perlite, etc. Put it in the prepared flowerpot and water it until it is slightly wet.
4. Sterilize the prepared cuttings with Carbendazim and put them in the shade for 1 day.
(author: Mint cotton skirt source: hyacinth bar)
5. Insert the branches of Florist Kalanchoe into the prepared soil, put them in a cool and ventilated place for a few days, and then just keep the soil moist, about half a month, they can take root.
(author: Yubei middle school principal source: cutting bar)
6. Tips: if you don't think you can see the rooting in the soil, you can insert the branches of Florist Kalanchoe into the water after the fourth step, and then transplant them after rooting.
(author: simple to silly source: Sina Weibo)
Aloe Vera has many advantages at home. It not only looks good, but also can purify the air. If you have good technology, it can even beautify your home.
Key points of ramet:
Generally, aloe vera grows to about 10 cm, and a lot of buds will burst out around it. These buds are the objects we want to plant.
2. Take all aloe and buds out of the flowerpot, clean the soil attached to the root system, and do not damage the root system.
3. Observe whether the buds have grown a complete root system. Only select the larger buds that have grown many roots, the survival rate will be higher. Don't choose buds without roots
4. After selecting the bud, hold the growth point between the bud and the mother plant with your fingers, and then gently break it, the bud will fall, put the bud in the shade for about 1 day, waiting for the wound to dry.
5. Fill a part of soil in the selected flowerpot, don't fill it all up, then put the buds into the flowerpot, hold it by hand, then fill it slowly inside, pay attention to the root system when filling, let the root system unfold naturally, without too much soil, just bury the root system of aloe in it.
6. After the filling, gently press around the flowerpot with your fingers, pour water once at the same time, and then put it in a cool and ventilated place to slow down the seedlings, and a new root will grow in about a week!
Ivy is also one of the common plants in the family. Its leaves are special and evergreen all the year round. It is an indispensable decoration in the family.
Key points of branch insertion:
1. At the top of ivy, select a strong branch about 10cm to cut.
2. Remove all the leaves from the lower part of the branch, leaving only the top 2-4 leaves.
3. Poke a few holes under the disposable cup, put in the soil with good permeability ratio, or directly use pure perlite or vermiculite for cutting, the success rate is relatively high
(author: Mi Mi xiaoyitian source: Sina Weibo)
4. Use your fingers or chopsticks to poke a hole in the middle of the cup, put the branch into the soil, and compact it slightly to avoid the branch from tilting.
5. After the water is poured through, it can be placed in the place with bright indoor light. In the first few days, the basin soil should be kept wet. After one week, it can be wet after watering. If the temperature is right, it will take about 15 to 20 days to take root.
6. Don't rush to transplant after rooting, let it grow in the cup for about a month and a half before transplanting. At this time, its root system has grown well, and the possibility of transplanting survival increases!
Tiger skin orchid, because the leaf pattern is like tiger tail, and because the maintenance is very simple, it has become a frequent visitor in many flower friends.
Key points of leafcutting:
1. Take a healthy leaf of snake plant
2. If the leaves are very long, you can cut them into 5 ~ 10cm segments with a sharp knife. If the leaves are short, you can cut them directly.
Long leaf segments
Take off the short leaves.
3. Disinfect snake plant with carbendazim, or smear rooting powder on the wound of snake plant.
4. Prepare the container for leaf cutting, put the medium with good air permeability into it, such as river sand, peat, vermiculite, perlite, etc., and wet the soil slightly.
5. Insert the leaves into the soil 2 ~ 3cm.
Short cut
The whole leaf is inserted
(author: Xinghu Feiyue source: yuhuagu Forum)
6. Put the leafed snake plant in the bright indoor light, keep the pot soil moist, and if the temperature is right, it will grow in about one month.
(author: Xinghu Feiyue source: yuhuagu Forum)
7. Note that if the cutting is the leaves of Phnom Penh snake plant, then the new buds will not have Phnom Penh.
Crab claw orchid is an epiphyte with flat stems and colorful flowers. It is loved by people. The most common way to reproduce Christmas Cactus is stem insertion.
(author: 221.205.223. * source: Ximing mine bar)
Key points of stem insertion:
Cut a section of healthy stem from the plant of crabmail. Note that there must be at least two sections in a section.
(source: flower cultivation exchange)
2. Soak the solution of potassium permanganate or carbendazim for about 5 minutes to disinfect, and then put it in the scattering light for about 1 day to let the water on the body dry in the shade.
3. Put the soil mixed with peat and river sand 1:1 into the prepared container, and pour it through with water until it is slightly wet.
4. You can poke a hole in the soil with your fingers or chopsticks, enough to insert the branches of Christmas Cactus. Then insert the stem node of crabmail, and then cover it with soil and compact it slightly.
(author: sdtazzy source: osmanthus bar)
5. Keep the basin soil moist, about 6-8 weeks can take root and sprout.
After seeing so many breeding methods, have you learned some tricks? Go and have a try.
