1. Use scissors to cut down the thick and fresh vines of pothos. The scissors should be sterilized with a lighter in advance.
2. Cut the branch into several segments, each segment contains 2 segments, with 1 leaf and 1 bud point in the middle.
3. Prepare rotten leaf soil, peat soil and perlite, mix them evenly according to the ratio of 2:2:1, and it is better to eliminate the poison in advance, and sun them for a day without disinfection. And then spray water, make the soil slightly moist, you can use it to plant pothos!
4. Circle the vines and insert them vertically into the soil, with the leaves facing up.
5. After cutting, spray some water and put it in a cool and ventilated place. When the soil surface is dry, water it again and it will soon grow buds!
1. Don't throw away the long-lived flower branches that are cut down at ordinary times. Cut them clean and cut them into small sections, and then dry the wounds in a cool and ventilated place.
2. Prepare clean rotten leaf soil, mix some perlite, spray water, make the soil slightly moist and a little damp. If you don't have rotten leaf soil at home, you can use clean garden soil mixed with river sand.
3. Insert the lower end of the long-lived flower branch into the soil, water one side and put it on the astigmatic thing balcony or thing windowsill.
4. It doesn't take ten and a half days for the long-lived branches to grow many roots of white flowers!
5. After rooting, more sun exposure, water once a week or so, and potassium dihydrogen phosphate once a month. After a few months, it will bloom!
1. Break off the strong and thick leaves, cut the leaves into several segments, each segment is about 10 cm, after cutting, put them in a cool and ventilated place for 2 days.
2. If you see the cut of snake plant, it is a little atrophic and wilting, it means that it's ready to air. If you air it a little bit, it's faster to take root and has a higher survival rate.
3. Find a water cup, decorate the water, put the cut piece of snake plant into 3-5cm, be careful not to mix up the top and bottom, or it will not take root.
4. Change the water once every 4 days or so. Add a little bit of carbendazim to the water, so that the roots can grow in 2 weeks!
5. After rooting, add some nutritious liquid or aspirin to the water, about 2 months, you can grow buds!
1. Prepare a cleaning sponge for washing dishes, cut it into small pieces, and drill several holes each.
2. Cut the semi lignified branches of Sweet osmanthus, about 10-15 cm in length, keep 2-3 leaves at the upper end, and cut them obliquely at the lower end.
3. Put the branch into potassium permanganate solution, soak it for 5-10 minutes, and sterilize it. Insert the branch into the cleaning sponge.
4. Wrap the sponge with a wet paper towel soaked in water.
5. Put the sponge wrapped with wet tissue into a plastic bottle, and pour 1-2cm water into the bottom.
6. Put the plastic bottle cap on the lid, leave a gap, and then place it on the indoor Nanyang terrace, South windowsill, east-west balcony, east-west windowsill, etc.
7. Sponge, wet tissue can maintain high humidity, less than a month, osmanthus can take root!
1. Cut the healthy Gardenia branches that are half a year old, and cut off the lower branches, leaving only the top 2 leaves.
2. foam boxes that are not used in the house can be washed and pierced with holes.
3. One hole and one branch, insert Gardenia branches one by one into small holes, float in a container with water, and cover the upper layer with a plastic bag to keep moisture.
4. About ten and a half days, gardenia branches can grow small white roots!
5. After rooting, you can sun it gradually. After 1-2 weeks, you can transplant the branches into a separate pot for curing.
1. For cutting Prunus deltoides, you can use coconut brick, disinfect it 30-40 minutes in advance with carbendazim bubble water, knead it slightly after soaking, and pour it into a disposable cup.
2. Cut the boughs of Prunus deltoides into palms. Remove the leaves below, leaving only two pairs of leaves at the top.
3. Insert the boughs of Prunus deltoides into the coconut brick soil, then put them into the transparent storage box, spray water on the box wall of the storage box, and then cover the cover, do not cover tightly, leave some gaps.
4. Put the storage box in a cool and ventilated place, open the cover twice a day, spray water to keep moisture, keep water on the box wall, and take root in about 20 days.
1. Select healthy and strong Camellia branches, which grow for about half a year. This kind of branches are active in tissue and full of axillary buds, which are most likely to survive.
2. Trim the cuttings of Camellia, let each cuttings contain 2 leaves, and then put in the carbendazim solution seed to soak for 15-20 minutes, and then take out to dry.
3. Prepare clean river sand, soak and disinfect with potassium permanganate solution in advance, so as to reduce black pole and improve survival rate.
Disinfect the river sand, pour it into the flowerpot, spray it with clean water, and poke the hole on the surface of the soil with your fingers.
4. Insert the camellia branch into the hole, compact it slightly, cover it with a layer of film, and put it in the place of astigmatism and ventilation for maintenance. Turn on the water spray 1-2 times a day, and soon take root!
1. Use scissors to cut off healthy Rhododendron branches without diseases and insect pests, not too long about 5-10 cm, after cutting, soak in carbendazim for disinfection.
2. Prepare a mineral water bottle, cut it from the middle, leave a little connection, don't cut it completely
3. Use the awl to poke a number of permeable holes at the bottom of the plastic bottle, then put the clean perlite into the lower half of the plastic bottle, squat in the water container to soak the basin, or pour it through.
4. Insert the Rhododendron branches with many fungicides into the wet perlite, and then put them into the tray.
5. Glue the upper and lower parts of the plastic bottle with adhesive tape, pour water into the tray, and ensure that there is water in the tray all the time during Rooting!
6. Put the whole cutting device in the place with light and ventilation. In 1-2 months, the cuckoo will grow its roots ~!