ThePlantAide.com

How does happiness tree change earth to hurt a root to do, how to raise after hurting a root?

Saul Goodman
2020-11-16 11:23:35
Strong: Gardenia from the winter when the bud began to breed, until the summer to open flowers, after a lot of time in the middle, with a strong spirit. Eternal love: Since the flower bud after the birth of flowers, leaves are waiting for the flowers in full bloom, in order to meet the agreement, it is said that the eternal love. Joy: The blooming of flowers brings a kind of hope to the summer, so it is full of joy.

1. How to change the soil and hurt the root of the happiness tree

It takes a while for the tree to recover after repotting, but if it shows signs of yellowing, blackening, or even withering and falling, it may have hurt its roots when repotting.These problems are caused by root injuries that slow down the rate at which nutrients and water are absorbed, and then by inadequate nutrient supply.

The root system of the happiness tree belongs to the shallow root system, and it is easy to damage the root when repotting.If you find that you hurt the roots, you don't have to worry, you can take it out of the soil first, carefully prune the damaged roots, and then disinfect it and plant it back.And then slowly maintain.

However, after root pruning, the speed of supplying nutrients and water will be slower, while the demand for nutrients and water for plant growth is still relatively strong.So it needs to be pruned off some branches and leaves, which can reduce the evaporation of water and nutrient absorption of leaves.Ensure that there is enough nutrients and water to promote root recovery.

2. How to raise after hurting the root

First, remove the roots from the soil, cut off the damaged roots, disinfect them, and then plant them back into the soil. After that, pay attention to careful maintenance.

It should be noted that during this period of time after the root injury, do not fertilize, watering also have to wait three or four days later.In terms of watering, we need to control the amount of water, wait until the surface of the pot soil turns white before watering, and we must irrigate thoroughly, grasp the principle of "dry and thorough irrigation".In addition, it can be sprayed on the leaf surface to ensure that the leaf growth can also have a certain amount of water supply.In terms of environment, it needs to be maintained in a warm environment with scattered light and good ventilation to avoid strong light.

The Plant Aide - Plant experts around you

The Plant Aide - Plant experts around you

www.theplantaide.com