Recently, many people have bought gardenia, but if the pot is yellow soil when they buy it, it may not take a few days for the leaves to droop. It's better to change the pot once!
1. Hold the flowerpot with one hand, and gently take the Gardenia out of the flowerpot with the other hand.
2. If the root system and soil are tangled together, wet the root soil block with water bubble, and clean up the soil after soaking, which is called root washing.
3. After the root soil is cleaned, put it in a ventilated place to air, and then trim the redundant weak and old roots.
4. The soil for Gardenia planting can be 6 humus soil plus 4 sandy soil, which is slightly acid and very breathable.
5. Gardenia is fragile when it is just put into the basin, so it is better to water it in the way of soaking basin. Put the flowerpot in a basin with water, and move it out after 10 minutes.
6. Put the Gardenia in the half shade position, do not shine strong light. Cover it with plastic bag, open it in the morning and in the evening, spray water, until new leaves grow, and then remove the bag
The fleshy flowerpots are generally small. If they don't change for more than two years, the root system in the flowerpot may have grown full, which will affect the fleshy growth. In addition, there are pests and black rot of meat should also change basin, to prevent secondary infection!
1. Use tweezers to poke along the edge of the basin to loosen the soil, and then gently take out the meat. As can be seen in the figure below, the succulent root system is already airtight, which is not conducive to root respiration, and prone to rot.
2. Loosen the soil at the root, trim off the redundant roots with the sterilized scissors, and then dry the wound in a cool place.
3. Prepare a basin a little larger than the original one, first lay a layer of ceramsite, and then add a little bit of wet special soil for meat. Then put the meat in the center of the basin, slowly fill and compact.
4. There is a period of basin serving stage for the fleshy people who have just been in the basin. When they are in the basin, they are wet soil. During this period, they can control water first. Wait until a week later, the soil feels dry before pouring
Longevity flower skin solid and love long, basic a year to change basin 1 ~ 2 times. If your longevity flower hasn't been thanked, you can wait until it is
1. Control water for a period of time before changing pot of Florist Kalanchoe. It is easy to hurt roots when changing pot with wet soil.
2. The root system of Florist Kalanchoe is relatively small, so it is not necessary to repair the root, and the original soil can also be retained, and it can be directly filled in a new basin.
3. The newly filled soil can be mixed with some compound fertilizer, which is determined by the size of the flowerpot. Generally, the dosage is no more than 8 at a time.
4. After planting, water once. The temperature of water should be about the same as that of room temperature.
5. If the long-lived flower branch is long, you can trim it when changing the pot, and insert the branch into the pot. The survival rate is basically 100%!
The fleshy root of orchid is very easy to grow in a full pot. If it has lateral buds, it will be more crowded in the pot. You can grow when you change the pot in time!
1. Use a screwdriver to draw a circle along the flowerpot to separate the soil from the flowerpot, and take out the orchid according to the trend.
2. Loosen the soil around the root system, shake the root system, and clean up the soil on the root system.
3. Prune the dry and empty roots, rotten roots and weak roots.
4. After trimming, put the root into the carbendazim solution for 10 to 15 minutes to disinfect, and then take it out to dry.
5. After the roots are dried, plant them in a new pot. The next day, water the roots again, so it is not easy to rot.
In general, the potted rose flowers need to be changed once every 1 to 2 years, because the nutrients in the flowerpot are relatively less, long-term non change will cause the rose to blossom less, or even not!
1, rose grows faster, so when changing basin, new basin had better be 1 times bigger than original basin..
2. After adding some ventilating large granule planting materials to the bottom of the basin, sprinkle a thin layer of soil, and then put some basal fertilizer, such as fermented sheep dung egg, don't use too much.
3. After the bottom fertilizer is put, continue to fill the soil. From time to time, put the rose in the new basin to see the difference between the soil surface of the original basin and the new basin, and stop filling until it is in normal time.
4. Take the rose out of the basin. Do not water it before changing the basin. It is not easy to damage the root when changing the basin when the soil is dry.
5. Put the rose in the middle of the new basin, fill in the flower soil at the same time, and gently compact it with your hands. Especially the flower soil on the edge of the basin must be compacted.
6. After the soil is filled, the root setting water shall be poured through. If the basin bottom starts to flow within 15 seconds, and the water is completely penetrated within 1 minute, it proves that the soil in the flowerpot has good water permeability.
7. Don't bask in the sun after changing the basin. After 10 to 15 days, the rose can be used for a period of time.
