1. First of all, make sure that the mother plants of the collected seeds are in good growth conditions and free of diseases and insect pests. Then store them for the next year. With the seeds, then the seeds. Elsholtzia Mosla has two sowing times a year - spring sowing in the first and middle of April, and summer sowing in the last ten days of May to the first ten days of June.
2. The sowing method can be organized sowing or sowing
3. When sowing, the seeds shall be sown into the fine soil and covered with a thin layer of fine soil, and the seedling rate and uniformity of the seeds shall be ensured with light pressure.
4. Then cover it with film or straw curtain to store water, and remove the film or straw curtain when the seedlings are unearthed.
5. Finally, when the seedlings are 15cm long, they can be planted separately. Split planting is the distance between plants. Generally, the spacing between plants is 30cm * 30cm. After splitting, Elsholtzia Mosla can grow normally, so sowing and propagation are finished.
1. In the first ten days of June, take the branches with good growth and relatively rough and healthy, disease-free and pest free, cut them to grow about 12-15cm branches and ears, each ear should have 2-4 full buds that have already grown, the cutting mouth of the cuttings should be flat on the top and inclined on the bottom, remove more than half of the leaves below the cuttings, and pay attention to keep the smoothness of the cutting mouth at the bottom.
2. The cuttings are separated by two coarseness of 0.3cm and 0.6cm, and then divided into four bundles on average. The length and size of the cuttings between the bundles shall be uniform, and the bottom end shall be aligned. The cuttings shall be tied in accordance with the normal method, and they shall be put into the medicine quickly without delay, because it is necessary to prevent excessive evaporation of water to ensure the healthy growth of the cuttings. It should be noted that the test agents are respectively rooting powder, etc., and compared with clear water, and the cutting depth is generally about 1 /3 of the cuttings.
3. Finally, observe the performance of Elsholtzia
Having said so much, now you know about the breeding way of Elsholtzia
