1. Make a frame for the rose to make a style, and the rose will not grow disorderly. The Chinese rose that uses to make style takes off a basin, bury in the ground, also can be made in flowerpot directly..
2. Insert 4 2-meter iron bars or bamboo strips around the rose, and put them in the flowerpot directly against the wall of the flowerpot.
3. Strip the rose, so as to promote the new shoots to grow more tender and stronger, and the growth speed of the new shoots is very fast, so as to facilitate the later rattan climbing treatment.
4. In about one month, the new shoots can grow to the extent that they can be twigged. Wind the rose branches horizontally and diagonally around the iron rod as much as possible, so as to play a role of cross pulling and promote the explosion of bamboo shoots. After wrapping, tie the iron rod with a binding rope or tape.
5. Don't break the thick branches at the bottom, or it will be easy to break. You can stick them obliquely from the bottom.
6. Such a rose style is ready! After the rose branches grow, you can keep on Panzhihua!
1. Prepare a PVC pillar with a diameter less than 5cm. Use the electric drill to drill several rows of holes on the pipe wall.
2. Find a plastic bottle with a diameter of more than 5cm, cut off the bottom of the bottle, cut several 5mm openings along the direction from the bottom to the mouth, and cut to about 5cm from the mouth.
3. Cut off the bottle mouth about 3cm away from the opening, so that the plastic bottle can just be stuck on the PVC pipe.
4. Prepare another plastic bottle, cut off the relatively smooth part of the bottle, roll it into a cylinder, and insert it at the water outlet at the bottom of the flowerpot.
5. Put the end covered with plastic bottle down, put the PVC pipe into the flowerpot, pour the cement and fix it. The plastic pipe inserted in the drain should always rotate, wait for the cement to set and then pull out.
6. Find a relatively absorbent cloth and plug it into the PVC pipe. In the later stage, it can provide water for the pothos.
7. Fill the plastic bottle at the bottom of the PVC pipe with the plant material, which can be tied with a rope to avoid scattering. The solidified cement surface is first laid with a layer of gauze net and then poured with soil, otherwise the drain is easy to be blocked.
8. After laying the gauze net, fill the prepared basin and plant the pothos. When the pothos is higher than the planting bottle, you need to add more bottles and planting materials. It won't be long before the pothos can grow into a style!
1. Prepare a number of thick and thin iron wires, scissors and pliers. If there is no wire at home, it can be replaced by old wire.
2. Wrap the wire around the edge of the flowerpot, try to fit the wall of the flowerpot, and then cut the wire and screw it into a circle.
3. Cut 6 pieces of thin iron wire about 10cm long and tie them evenly on the big circle made between them. After binding, put the big circle on the flowerpot..
4. Cut 3 pieces of 2-meter-long thick iron wire, bend and fold them in half from the middle, and simply tie them together.
5. Divide the bottom of the three wires evenly and insert them into the flower pot. Fix the thick wire in the flowerpot with the 6 thin wires tied on the big circle.
6. Make several circles with the remaining iron wire, and the diameter is similar to the size of the flowerpot.
7. Take apart the wire at the top of the flower stand, connect the top of the three thick iron wires with a good circle, and put the rest of the iron rings on the outside of the flower stand at one time, and a flower stand of Clematis climbing rattan is ready!
8. With the support of the flower stand, Clematis can't stop crawling, and the flowers will come out!
