It's better after flowering, or from May to June.
We can choose river sand or vermiculite considering drainage performance, nutrient content, air permeability and many other factors.
After flowering, when cutting off the inflorescence, we can cut off the flower branch with the tip by the way, and pay attention that the cut flower branch should not be too long, five to ten centimeters. After cutting, we need to cut off the lower part of the blades, and the upper part of the blades can only leave half. Then, insert them into the matrix that we have prepared. Ensure the temperature, humidity, ventilation and other conditions, about a month or so it can be observed to take root. When their leaves grow out, they can be transplanted
When selecting an insert, you can also select three or four sections of the segment. Also, if it's cutting in spring, we can do it with the one put in the basin.
In order to improve the survival rate, we have to choose those robust branches that are free of diseases and pests.
First of all, hydroponics. Then, when the new branches grow out, we will take them out, soak them in alcohol for about half a minute, and then sterilize them. Next, cut the base of the stem with sterilized scissors and put it on the medium for culture. After a period of culture, it was removed and sterilized, and planted in the substrate. Make sure the surrounding humidity is sufficient and take care not to shine in the sun. In this way, you can control the success rate at 90%.
