Flower cultivation Daquan
1. Preparation tools: wire, iron bar, thick wire, thin wire, pliers
3. Try to make the wire into a circle, and make both wires into a circle.
Flower cultivation Daquan
1. Prepare tools: nails, boards, saws
3. Prepare four boards of the same length and a thick stick. Put the thick stick in the middle of the base, then on the four corners and the stick.
4. Then prepare short boards according to the proportion, according to the proportion between the two boards,
5. As shown in the figure below, nail the boards one by one.
2. Separate several round holes on PVC pipe.
3. Put PVC pipe in flowerpot, fill with soil and plant flowers.
2. Cut the PVC pipe into two parts, and the joint into two parts. Remember to cut vertically, not horizontally. Pay attention to safety!
4. Wrap the wire around the two ends of the PVC pipe and hang it directly, so as to avoid drilling holes on the PVC pipe.
Flower cultivation Daquan
3. Then use fire to bake in the sawed place, and then press down with hard things. If the material of the big barrel is soft, you can bake without fire, and press down directly.
