Pouring pot is to take out the seedlings from the original pot without damaging the plants. Before pouring the basin, it is necessary to pay attention not to water, and keep the basin soil properly dry, so that the mud can be poured out completely.
Specific operation method: hold the basin with one hand, clench the fist with one hand, and tap the flowerpot gently, so that there is a gap between the soil and the basin wall, and then it will fall off naturally. If the flowerpot is large, when the soil is loose, hold it by hand and take it out.
Peel off part of the mud at the root of the plant, cut off the excessively long and injured root, and then put it into the basin. If the mud is surrounded by new white roots, it's not necessary to prune them, just put them in the basin.
Find a relatively high place before using the basin, such as a small table, which can improve efficiency. In addition, all kinds of materials: flowerpots, soil and gardening tools should be prepared.
Cushion basin: find some broken tiles and cover them on the drain hole. The concave side is downward, which can not only block the drain hole, but also keep the soil from leaking out.
Upper basin: add a small amount of coarse sand into the flowerpot, then support the seedlings with one hand, and plant the plants upright in the flowerpot. With the other hand, add soil to the basin until it is full. Then gently shake the flowerpot so that the soil and the flowerpot are closely combined. After the basin is poured, the water will be permeable. After the water is absorbed, the water will be poured again. After potting, the plant needs a recovery period of 3-7 days.
In the process of potting, do not damage the leaves or break the stems and branches, otherwise the recovery period of the plant will be prolonged. In addition, all tools in the process of operation shall be disinfected, especially the soil, which shall be exposed to the sun or stir fried in a hot pot under high temperature, so as to avoid bacteria in the soil after basin change.
