ThePlantAide.com

After drinking in summer, we can cut the scissors and raise flowers.

Jane Margolis
2020-07-29 16:46:47
Huahua found a lot of cans at home when she was packing things at weekends. No matter what was left over from beer or drink, there was no place for more! But later Huahua thought of a good way, which is to process these cans to make flowerpots. It's just wonderful!

Operation steps:

1. Draw a line on the can according to the height you like. When you can cut it, cut along the line. If it's a cactus or something, it doesn't need too much soil. It can be painted lower

2. Cut the cans with scissors along the lines drawn on the cans before. When cutting, you must pay attention to your hands and never get hurt.

3. Use scissors to cut out a strip with width of about 7cm, and then use chopsticks to turn out the aluminum strips one by one according to the method shown in the figure below to make a beautiful petal shape.

4. Open a drain hole at the bottom of the can, and you can use the sharpening stone of the kitchen knife at home to finish it.

5. Just a few simple steps, a simple small flowerpot is ready

6. It's so beautiful to use the small flowerpot made by the can to raise cactus and other flowers.

Operation steps:

1. Find a can, cut off the bottom of it, and then cut off the burr of the incision, so as to make the cutting surface as smooth as possible.

2. Use copper wire or iron wire to make a circle that can just cover the outside of the can.

3. Cut the cans about 2cm longitudinally, and the number of cuts can be even. It will be more beautiful to do so, and then put the circle made before

4. Every 1 piece apart, fold the edge of the can down and wrap it on the circle.

5. After the package is complete, it is like this as shown in the figure below.

6. Find a toothpick, cut the part about 3cm away from the tip, and roll it up with the can until all the edges of the raised can are rolled down.

7. Take the bottom of the can that was cut off before, and then put the concave side down on the bottom of the can, so that a small flowerpot is ready

8. In a good pot pot, add soil, and then put the plants you want to plant in it.

Operation steps:

1. Cut the cabbage into two parts. Keep the stem of the cabbage.

2. Fold the cover of the can in half, then stretch your finger into the pull ring, cut the stem of Chinese cabbage, each piece can cut several layers

3. Cut off the redundant part of the cabbage, and pay attention to the cut part. Never cut it, or you will lose all your previous achievements.

4. Unfold the cabbage in the water, and it becomes a beautiful cabbage flower.

Operation steps:

1. Prepare two beer cans and a basin of small plants, such as aloe.

2. Draw an ellipse with white paper and cut it off. Use it as a template and cut a hole on the side of the can.

3. In this way, the edges of the cans are sharp. In order to prevent tying, you can trim them in a small range along the edges of the cans, and fold the part of the cut in, so that you won't be afraid to scratch your hands.

4. Clean the clipped cans again, dry them, and then paint them with white background color, and then draw their own favorite patterns or colors.

5. The cans after drawing are like the following

6. Put the soil in, and then plant the aloe plants prepared before into the soil, so as to make a small pot, and then hang a rope on the top of the pot, and you can hang it anywhere.

The Plant Aide - Plant experts around you

The Plant Aide - Plant experts around you

www.theplantaide.com